Removal And Installation: Installation
WARNING: This page is about a different variant/trim than selected.
Only tighten the bolts finger tight at this stage.
Torque Specification: 115 Nm
- Lower the engine onto the engine mounting.
Only tighten the nut finger tight at this stage.
-
Torque Specification: 40 Nm
Torque Specification: 130 Nm
Torque Specification: 25 Nm
- Install a new bolt.
- Torque Specification: 30 Nm
- Renew Part: Steering column lower shaft lower bolt Quantity: 1 .
Torque Specification: 10 Nm
Torque Specification: 10 Nm
- Install the generator.
Refer to: GENERATOR
- Connect the startup battery ground cable.
Refer to: SPECIFICATIONS