Removal And Installation: Installation
WARNING: This page is about a different variant/trim than selected.
-
CAUTION: Make sure that the mating faces are clean and free of foreign material.
- Clean and inspect the cylinder head and cylinder block.
- Check the cylinder head face for distortion, across the center and from corner to corner. Refer to: Cylinder Head Distortion
- CAUTION: Only tighten the bolts finger-tight at this stage.NOTE: Install a new gasket.
Renew Part: Cylinder head bolts Quantity: 1 .
Renew Part: Cylinder head gasket Quantity: 1 .
-
Tighten the bolts in the indicated sequence.
Torque Specifications:
Stage 1: 80 Nm
Stage 2: 180°
- Refer to: RIGHT CAMSHAFT
Torque Specification: 10 Nm
Torque Specification: 10 Nm
- Refer to: RIGHT EXHAUST MANIFOLD
- Connect the battery ground cable
Refer to: SPECIFICATIONS
- Refer to: HIGH-PRESSURE FUEL SYSTEM BLEEDING