Removal And Installation: Removal

WARNING: This page is about a different variant/trim than selected.

NOTE: This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.

Drain the cooling system.

Refer to: COOLING SYSTEM PARTIAL DRAINING AND VACUUM FILLING
Disconnect the startup battery ground cable.
Refer to: SPECIFICATIONS
Remove the right valve cover.
Refer to: RIGHT VALVE COVER
Remove the oil filter.
Refer to: OIL FILTER ELEMENT
Remove the glow plugs.
Refer to: GLOW PLUGS
Disconnect the vacuum tubes.
Remove the vacuum reservoir.
CAUTION: Be prepared to collect escaping coolant.

Disconnect the coolant hoses.
CAUTION: Be prepared to collect escaping coolant.

NOTE: Remove and discard the seals.

Remove the engine coolant outlet.

NOTE: Remove and discard the seals.
Remove the oil cooler.