LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2016 >> Range Rover Supercharged >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Engine - TDV6 3.0L Diesel - Gen 2/TDV6 3.0L Diesel -- Range Rover/L405) >> Engine - TDV6 3.0L Diesel - Gen 2/TDV6 3.0L Diesel >> Left Exhaust Manifold >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page is about a different variant/trim than selected.
  1. G11756114

    Torque Specification: 7.5 Nm 

  2. G11756113

    Torque Specification: 28 Nm 

  3. CAUTION: Make sure that new nuts are installed.
    NOTE: Install new gaskets.
    G11756112

    Renew Part: Exhaust manifold nuts Quantity: 1  .

    Renew Part: Exhaust manifold gasket Quantity: 1  .

    Renew Part: Crossover pipe gasket Quantity: 1  .

  4. NOTE: Tighten the bolts in the indicated sequence.
    Fig 1: Exhaust Manifold Bolts Tightening Sequence
    G11602024Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

    Torque Specification: 24 Nm 

  5. CAUTION: Install new studs.
    G11756111

    Renew Part: Exhaust manifold cross-over pipe studs Quantity: 1  .

    Torque Specification: 24 Nm 

    CAUTION: Make sure that new nuts and bolt are installed.
  6. G11756110

    Renew Part: Exhaust manifold cross-over pipe nuts and bolts Quantity: 1  .

    Torque Specification: 24 Nm 

  7. G11756109
  8. Refer to: LEFT TURBOCHARGER - TDV6 3.0L DIESEL - GEN 2, VEHICLES WITHOUT: HYBRID SYSTEM