Removal And Installation: Installation

WARNING: This page is about a different variant/trim than selected.

CAUTION: Make sure that the mating faces are clean and free of foreign material.
- Clean and inspect the cylinder head and cylinder block.
- Check the cylinder head face for distortion, across the center and from corner to corner. Refer to: CYLINDER HEAD DISTORTION
  Refer to: CYLINDER HEAD GASKET SELECTION - TDV6 3.0L DIESEL
CAUTION: Only tighten the bolts finger-tight at this stage.

NOTE: Install a new gasket.

Renew Part: Cylinder head gasket Quantity: 1 .

Renew Part: Cylinder head bolts Quantity: 1 .
NOTE: Tighten the bolts in the indicated sequence.

Fig 1: Cylinder Head Bolts Tightening Sequence
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Torque Specification: 80 Nm
NOTE: Tighten the bolts in the indicated sequence.

Fig 2: Cylinder Head Bolts Tightening Sequence
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Torque Specification: 180°
CAUTION: Install the new seals.
Renew Part: Water outlet connection O-ring seals Quantity: 1 .

Torque Specification: 10 Nm
Torque Specification: 10 Nm
Torque Specification: 24 Nm
Torque Specification: 14 Nm
Refer to: LEFT EXHAUST MANIFOLD
Refer to: GLOW PLUGS
Refer to: LEFT CAMSHAFT
Refer to: SPECIFICATIONS