Removal And Installation: Installation

WARNING: This page is about a different variant/trim than selected.

CAUTION: Make sure that new bolts are installed.

NOTE: Make sure that all the component mating faces are clean.
- Prevent the flexplate from rotating.
  Renew Part: Flywheel bolts Quantity: 1 .
CAUTION: Tighten the bolts evenly in the stages shown.

Fig 1: Flexplate Bolts Tightening Sequence
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Stage 1: Tighten to 50 Nm.
- Stage 2: Tighten to 45 degrees.
- Stage 3: Tighten to 45 degrees.
- Remove the special tool.
- Special Tool(s): 303-1123
Refer to: TRANSMISSION - TDV6 3.0L DIESEL
Refer to: STARTER MOTOR
Connect the battery ground cable.
Refer to: SPECIFICATIONS