Engine (Removal): Removal: Part(S)
WARNING: This page is about a different variant/trim than selected.
| STEP | PART NAME | QUANTITY |
|---|---|---|
| Step 36 | Steering column lower shaft lower bolt | 1 |
CAUTION:
Make sure that all openings are sealed. Use new blanking caps.
NOTE:
Some variation in the illustrations may occur, but the essential information is always correct.
- Disconnect the battery ground cable.
Refer to: SPECIFICATIONS
-
WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
- Refer to: HOOD
- Refer to: COOLING SYSTEM PARTIAL DRAINING AND VACUUM FILLING
- Refer to: INTAKE AIR SHUTOFF THROTTLE
- CAUTION: Be prepared to collect escaping coolant.
-
CAUTION: Be prepared to collect escaping coolant.
-
CAUTION: Be prepared to collect escaping fluids.
-
CAUTION: Be prepared to collect escaping coolant.
- CAUTION: Be prepared to collect escaping coolant.
-
CAUTION: Take extra care not to damage the surrounding components.
- Refer to: ACCESSORY DRIVE BELT
-
CAUTION: Discard the bolt.NOTE: RHD shown, LHD is similar.
Align the steering wheel to straight ahead.
Renew Part: Steering column lower shaft lower bolt Quantity: 1 .
- Refer to: SECONDARY BULKHEAD CENTER PANEL - TDV6 3.0L DIESEL
-
CAUTION: Be prepared to collect escaping coolant.
-
CAUTION: Be prepared to collect escaping fuel.
Special Tool(s): 303-1141 , 303-1141-01
- Install the special tool.
Special Tool(s): 303-021
- Install the special tool.
- Refer to: TRANSMISSION - TDV6 3.0L DIESEL
- Remove the special tool.
Special Tool(s): 303-021
- Remove the special tool.
-
WARNING: This step requires the aid of another technician.CAUTION: Be prepared to collect escaping fluids.
Carefully and progressively raise and remove the engine.