Special Tool(S)
WARNING: This page is about a different variant/trim than selected.
| 303-021 Engine support bracket |
|
| 303-1141 Engine lifting kit |
|
| 303-1141-01 Engine lifting bracket - Rear |
CAUTION:
Make sure that all openings are sealed. Use new blanking caps.
NOTE:
Some variation in the illustrations may occur, but the essential information is always correct.
-
WARNING: This step requires the aid of another technician.CAUTION: Be prepared to collect escaping fluids.
Install the special tool.
Special Tool(s): 303-021
Torque Specification: 110 Nm
Torque Specification: 110 Nm
Torque Specification: 9 Nm
- Refer to: TRANSMISSION - TDV6 3.0L DIESEL
Torque Specification: 12 Nm
Remove the special tool.
Special Tool(s): 303-021
Remove the special tool.
Special Tool(s): 303-1141 , 303-1141-01
Torque Specification: 8 Nm
Torque Specification: 8 Nm
Torque Specification: 8 Nm
Torque Specification: 10 Nm
Torque Specification: 10 Nm
- Refer to: SECONDARY BULKHEAD CENTER PANEL - TDV6 3.0L DIESELCAUTION: Make sure that a new bolt is installed.CAUTION: Make sure that a new bolt is installed.
- Torque Specification: 30 Nm
Torque Specification: 25 Nm
- Refer to: ACCESSORY DRIVE BELT
Torque Specification: 7 Nm
Torque Specification: 10 Nm
Torque Specification: 6 Nm
Torque Specification: 6 Nm
Torque Specification: 6 Nm
Torque Specification: 10 Nm
- Refer to: INTAKE AIR SHUTOFF THROTTLE
- Refer to: HOOD
- Disconnect the battery ground cable.
Refer to: SPECIFICATIONS
- Refer to: LOW-PRESSURE FUEL SYSTEM BLEEDING