LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2016 >> Range Rover Supercharged >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Engine - TDV6 3.0L Diesel - Gen 2/TDV6 3.0L Diesel -- Range Rover/L405) >> Engine - TDV6 3.0L Diesel - Gen 2/TDV6 3.0L Diesel >> Crankshaft Rear Seal >> Removal And Installation >> Removal

Removal And Installation: Removal

WARNING: This page is about a different variant/trim than selected.
NOTE: Removal steps in this procedure may contain installation details.
  1. Disconnect the battery ground cable.

    Refer to: SPECIFICATIONS

  2. WARNING: Make sure to support the vehicle with axle stands.

    Raise and support the vehicle.

  3. Refer to: CRANKSHAFT POSITION SENSOR RING
  4. G11601930
  5. CAUTION: Discard the seal.
    G11601931
scientia non olet · About LEMON Manuals