LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2016 >> Range Rover Supercharged >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Engine - TDV6 3.0L Diesel - Gen 2/TDV6 3.0L Diesel -- Range Rover/L405) >> Engine - TDV6 3.0L Diesel - Gen 2/TDV6 3.0L Diesel >> Crankshaft Rear Seal >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page is about a different variant/trim than selected.
  1. CAUTION: Make sure that the crankshaft rear oil seal is correctly located.
    G11601932

    Apply an 8 mm bead of sealant to the cylinder block in the areas shown.

    Renew Part: Crankshaft rear seal Quantity: 1  .

  2. G11601933
    • Lubricate the oil seal.
  3. G11601934

    Torque Specification: 10 Nm 

  4. G11601935

    Torque Specification: 10 Nm 

  5. G11601930

    Torque Specification: 10 Nm 

  6. Refer to: CRANKSHAFT POSITION SENSOR RING
  7. Connect the battery ground cable

    Refer to: SPECIFICATIONS

scientia non olet · About LEMON Manuals