LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2016 >> Range Rover Supercharged >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Engine - TDV6 3.0L Diesel - Gen 2/TDV6 3.0L Diesel -- Range Rover/L405) >> Engine - TDV6 3.0L Diesel - Gen 2/TDV6 3.0L Diesel >> Crankshaft Front Seal - TDV6 3.0L Diesel - Gen 2 >> Removal And Installation >> Removal

Removal And Installation: Removal

WARNING: This page is about a different variant/trim than selected.
NOTE: Some variation in the illustrations may occur, but the essential information is always correct.
  1. WARNING: Make sure to support the vehicle with axle stands.

    Raise and support the vehicle.

  2. Disconnect the battery ground cable.

    Refer to: SPECIFICATIONS

  3. Remove the timing belt.

    Refer to: TIMING BELT 

  4. G11695485

    Install the special tool.

    Special Tool(s): 303-1123 

  5. Remove the crankshaft pulley.

    Refer to: CRANKSHAFT PULLEY - TDV6 3.0L DIESEL - GEN 2 

  6. G11695486

    Install the special tool to the crankshaft.

    Special Tool(s): 303-1120 

  7. G11695487

    Install the special tool to the crankshaft, rotate the special tool to engage the crankshaft front oil seal as shown.

    Special Tool(s): 303-1120 

  8. G11695488

    Rotate the special tool release bolt.

    Special Tool(s): 303-1120 

  9. G11695489

    Using the special tool, remove and discard the crankshaft front oil seal.

    Special Tool(s): 303-1120 

scientia non olet · About LEMON Manuals