Removal And Installation: Installation

WARNING: This page is about a different variant/trim than selected.

CAUTION: Do not use any lubricant on the crankshaft front seal, special tools or the crankshaft. Failure to follow this instruction may result in damage to the vehicle.

NOTE: Make sure that all the component mating faces are clean.

Install a new crankshaft front seal to the special tool.

Special Tool(s): 303-1122

Renew Part: Crankshaft front oil seal Quantity: 1 .
Reposition the crankshaft front seal along the special tool.

Special Tool(s): 303-1122
Install the special tool to the crankshaft.

Special Tool(s): 303-1122
Remove the special tool.
Install the special tool to the crankshaft.

Special Tool(s): 303-1121
NOTE: Make sure the seal is installed correctly.

Using the special tool, install the crankshaft front oil seal.

Special Tool(s): 303-1121

CAUTION: Make sure the seal is installed correctly.

NOTE: Wait 10 seconds before removing the crankshaft seal installation tool.
Remove the special tool.
Install the crankshaft pulley.
Refer to: CRANKSHAFT PULLEY - TDV6 3.0L DIESEL - GEN 2
Remove the special tool.

Special Tool(s): 303-1123
Install the timing belt.
Refer to: TIMING BELT
Connect the battery ground cable.
Refer to: SPECIFICATIONS