LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2016 >> Range Rover Supercharged >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Engine - TDV6 3.0L Diesel - Gen 2/TDV6 3.0L Diesel -- Range Rover/L405) >> Engine - TDV6 3.0L Diesel - Gen 2/TDV6 3.0L Diesel >> Camshaft Rear Seal >> Removal And Installation >> Removal

Removal And Installation: Removal

WARNING: This page is about a different variant/trim than selected.
NOTE: Some variation in the illustrations may occur, but the essential information is always correct.
  1. Refer to: REAR END ACCESSORY DRIVE
  2. G11601763

    Install the special tool.

  3. G11601764

    Install the special tool.

  4. G11601765

    Using the special tool, remove the rear camshaft pulley retaining bolt.

  5. Remove the special tools.
  6. G11601766
    CAUTION: Make sure the special tool is correctly seated behind the camshaft seal. Failure to follow this instruction may result in damage to the special tool.
  7. G11601886

    Install the special tool.

  8. G11601887
scientia non olet · About LEMON Manuals