DTC U0426-31: Invalid Data Received From Vehicle Immobilizer Control Module - No signal: Action
WARNING: This page is about a different variant/trim than selected.
NOTE:
The FlexRay wiring harness must not be repaired by making a localized wiring repair. A new wiring harness should be installed.
- Refer to the appropriate system wiring diagram and check the body control module power and ground circuits for open circuit, high resistance. Repair the wiring harness as necessary
- Refer to the appropriate system wiring diagram and check the FlexRay bus circuit for short circuit to ground, short circuit to power, open circuit, high resistance. Repair the wiring harness as necessary
- Using the Jaguar Land Rover approved diagnostic equipment, check the body control module for related DTCs and refer to the relevant DTC index