Possible Causes
WARNING: This page is about a different variant/trim than selected.
- Purpose of the DTC
- Oil level sensor doesn't update the information for 10 seconds
- Electrical Cause
- Yes
- Mechanical Cause
- Yes
- Control Module Cavity
- Circuit reference I_T_OCS
- Circuit reference G_G_OCS
- Monitor Description
- The status of the oil level sensor is "Waiting" for more than 10 seconds
- The powertrain control module has determined failures where one (or more) expected message (s) is not received, e.g periodic transmission where the repetition time is too high, or message not received as a result of unforeseen reset events of the concerning component (e.g. powertrain control module communication with oil level and temperature sensor)
- Oil level and temperature sensor circuit short circuit to ground, short circuit to power, open circuit, high resistance
- Connector is disconnected, connector pin is backed out, connector pin corrosion
- Oil level and temperature sensor failure