Possible Causes
WARNING: This page is about a different variant/trim than selected.
- Purpose of the DTC
- The DTC was implemented to set when the oil temperature value is not between the plausibility limits
- Electrical Cause
- Yes
- Mechanical Cause
- Yes
- Control Module Cavity
- Circuit reference I_T_OCS
- Circuit reference G_G_OCS
- Monitor Description
- The read of oil temperature is not between the plausibility limits
- The powertrain control module detected plausibility failures
- Oil level and temperature sensor circuit short circuit to ground, short circuit to power, open circuit, high resistance
- Connector is disconnected, connector pin is backed out, connector pin corrosion
- Oil level and temperature sensor failure