DTC P250B-64: Engine Oil Level Sensor Circuit Range/Performance - Signal plausibility failure: Action
WARNING: This page is about a different variant/trim than selected.
- Diagnosis of this DTC may require using the Jaguar Land Rover approved diagnostic equipment check datalogger signals
- 0x03E6 Engine Oil Level - Measured
- 0x03F2 Engine Oil Volume - Calculated
- 0x03F3 Sump Oil Temperature - Measured
- Refer to the appropriate system wiring diagram and check the oil level and temperature sensor circuit for short circuit to ground, short circuit to power, open circuit, high resistance
- Inspect connectors for signs of water ingress, and pins for damage and/or corrosion
- Check and install a new oil level and temperature sensor as required
- Only if an oil change occurs before or after repair. Using the Jaguar Land Rover approved diagnostic equipment carry out 'Oil service counter reset' routine (0x4024)
- Using the Jaguar Land Rover approved diagnostic equipment, clear the DTCs and retest