LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2016 >> Range Rover Supercharged >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Rear Disc Brake -- Range Rover/L405 >> Rear Disc Brake >> Brake Pads - Vehicles With: High Performance Brakes >> Removal And Installation >> Removal

Removal And Installation: Removal

WARNING:
  • Brake pads must be renewed in axle sets only. Failure to follow this instruction may result in braking efficiency being impaired.
  • If the brake pad wear warning light has been activated, a new brake pad wear sensor must be installed.
NOTE:
  • Some variation in the illustrations may occur, but the essential information is always correct.
  • Left illustration shown, right is similar.
  1. Connect the diagnostic tool and set the electronic park brake (EPB) to the maintenance position.
  2. NOTE: This step is only required if the diagnostic tool is not available.

    Refer to: ELECTRIC PARK BRAKE SERVICE MODE ACTIVATION AND DEACTIVATION .

  3. NOTE: This step is only required if the vehicle has no battery power.

    Refer to: ELECTRIC PARK BRAKE RELEASE WHEN THE VEHICLE HAS NO ELECTRICAL POWER .

  4. WARNING: Make sure to support the vehicle with axle stands.

    Raise and support the vehicle.

  5. Refer to: WHEEL AND TIRE - TDV6 3.0L DIESEL/TDV8 4.4L DIESEL/V6 S/C 3.0L PETROL/V8 N/A 5.0L PETROL/V8 S/C 5.0L PETROL .
  6. CAUTION: The brake pad wear indicator sensor is easily damaged. Do not use a lever to remove the sensor. Use fingers only.
    NOTE: Right side only.
    G11693832

    Inspect the brake pad wear sensor for signs of wear or damage. Install a new sensor if necessary.

  7. G11693833
  8. G11693834
  9. Repeat the above procedure for the other side.
scientia non olet · About LEMON Manuals