Removal And Installation: Installation
- Install the shock absorber and spring assembly.
- Make sure the spring and shock absorber assembly top mounting to body mating faces are clean.
- Tighten the nuts to 63 Nm (46 lb.ft).
- Connect the shock absorber and spring assembly to the lower arm.
- Tighten the nut and bolt to 300 Nm (221 lb.ft).
- Install the wheel and tire.
- Tighten the wheel nuts to 140 Nm (103 lb.ft).
- For additional information, refer to: Air Suspension System Depressurize and Pressurize .