Removal And Installation: Radiator: Removal
WARNING: This page is about a different car, the 2012 Land Rover Range Rover Sport and 2011 Land Rover Range Rover Sport. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Removal steps in this procedure may contain installation details.
- Raise and support the vehicle.
- Refer to Air Conditioning (A/C) System Recovery, Evacuation and Charging .
- Refer to Radiator Grille .
- See COOLANT PUMP .
- Refer to Cooling Fan - Vehicles With: Supercharger .
- See figure
- See figure
- See figure
- See figure
- See figure
- See figure
Torque: 9 Nm
- See figure
- Torque: 9 Nm
- Torque: 10 Nm
- See figure
- See figure
- See figure
- See figure
- Torque: 25 Nm
- Torque: 10 Nm
WARNING:
Make sure to support the vehicle with axle stands.
NOTE:
Some variation in the illustrations may occur, but the essential information is always correct.
CAUTION:
Always plug any open connections to prevent contamination.
NOTE:
Some variation in the illustrations may occur, but the essential information is always correct.
CAUTION:
Before disconnecting or removing the components, make sure the area around the joint faces and connections are clean. Plug open connections to prevent contamination.
CAUTION:
Be prepared to collect escaping coolant.
NOTE:
Some variation in the illustrations may occur, but the essential information is always correct.
CAUTION:
Be prepared to collect escaping coolant.
CAUTION:
Always protect the cooling pack elements to prevent accidental damage.