LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2015 >> Range Rover Base >> Repair and Diagnosis >> Engine Mechanical >> Blowers, Superchargers & Turbochargers >> Fuel Charging & Controls - V6 S/C 3.0L Petrol -- Range Rover/L405 >> Fuel Charging And Controls - V6 S/C 3.0L Petrol >> Right Fuel Rail >> Removal And Installation >> Removal

Removal And Installation: Removal

CAUTION: Make sure that tools and equipment are clean and free of foreign material and lubricant.
NOTE: Some variation in the illustrations may occur, but the essential information is always correct.
  1. Refer to: PETROL AND PETROL-ETHANOL FUEL SYSTEMS HEALTH AND SAFETY PRECAUTIONS
  2. Refer to the appropriate fuel system pressure release procedure.
  3. Refer to: ENGINE COVER - V6 S/C 3.0L PETROL/V8 N/A 5.0L PETROL/V8 S/C 5.0L PETROL
  4. Disconnect the battery ground cable.

    Refer to: SPECIFICATIONS

  5. Refer to: AIR CLEANER OUTLET PIPE T-CONNECTOR
  6. G11607590
  7. Refer to: RIGHT AIR CLEANER
  8. CAUTION: Be prepared to collect escaping coolant.
    G11607322
  9. G11687513
  10. G11607534
  11. CAUTION: Be prepared to collect escaping coolant.
    G11607321
  12. G11607535
  13. G11607545
  14. WARNING: Do not smoke or carry lighted tobacco or open flame of any type when working on or near any fuel related components. Highly flammable vapors are always present and may ignite. Failure to follow these instructions may result in personal injury.
    CAUTION: Make sure that the fuel line union does not rotate.
    G11606983
  15. G11607603
  16. CAUTION: Be prepared to collect escaping fluids.
    G11607604
  17. G11710328
  18. NOTE: LH illustration shown, RH is similar.
    G11607547
  19. Refer to: FUEL INJECTION COMPONENT CLEANING 
  20. NOTE: LH illustration shown, RH is similar.
    G11607548
  21. CAUTION: Make a note of the fuel injector clamp alignment to the fuel rail prior to removal.
    NOTE: LH illustration shown, RH is similar.
    G11607549
  22. NOTE: This step is only required if a new fuel rail is installed.

    Refer to: FUEL RAIL PRESSURE SENSOR

  23. CAUTION: Make sure that the special tool is located correctly to the fuel injector prior to removing the fuel injector.
    G11607611

    Special Tool(s): 310-197 

  24. G11587674

    Remove and discard the fuel injector clamp.

  25. CAUTION: Do not use a knife to remove the Teflon seal as damage could occur to the fuel injector.
    G11607552

    Remove and discard the fuel injector seal.

  26. CAUTION: Do not use any sharp tools to remove the O-ring seal as damage could occur to the fuel injector.
    G11607553

    Remove and discard the fuel injector O-ring seals.

  27. WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.

    Raise and support the vehicle.

  28. Refer to: GENERATOR (REMOVAL AND INSTALLATION)
  29. G11606720
  30. G11607621
  31. G11607622
  32. G11712488
  33. G11710340
  34. CAUTION: Use a wooden block to protect the oil pan when supporting the engine.
    G11606753

    Using a suitable hydraulic jack, support the engine.

  35. G11710342
  36. WARNING: Do not smoke or carry lighted tobacco or open flame of any type when working on or near any fuel related components. Highly flammable vapors are always present and may ignite. Failure to follow these instructions may result in personal injury.
    CAUTION: Remove and discard the high-pressure fuel supply lines.
    NOTE: Engine shown removed for clarity.
    G11606937