LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2015 >> Range Rover Autobiography >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Engine Cooling - V6 S/C 3.0L Petrol -- Range Rover/L405) >> Engine Cooling - V6 S/C 3.0L Petrol >> Rear Coolant Manifold >> Installation

Rear Coolant Manifold: Installation

WARNING: This page is about a different variant/trim than selected.
  1. NOTE: This step is only required if new components are not installed.

    Install 2 new O-ring seals to the rear coolant manifold.

    Renew Part: Cylinder block coolant outlet O-ring seals Quantity: 2  .

    • Install the rear coolant manifold.
    • Install and tighten the 6 bolts.

      Torque  : 9 Nm 

    • Reposition the transmission breather pipes to the correct location.
    • Install the clip.
  4. Install the wiring harness clip to the left side of the rear coolant manifold.
    • Connect the electrical connector.
    • Install the 2 wiring harness clips to the right side of the rear coolant manifold.
    • Connect the rear coolant manifold left hose.
    • Install the coolant hose clip.
    • Install the coolant hose bracket.
    • Install and tighten the bolt.

      Torque  : 12 Nm 

    • Install the wiring harness clip.
    • Install the rear coolant manifold right hose.
    • Connect the 2 coolant hose connectors.
  9. Install and tighten the bolt to the coolant hose bracket.

    Torque  : 12 Nm 

    • Reposition the wiring harness into the correct location.
    • Install and tighten the 2 bolts.

      Torque  : 9 Nm 

  11. Install the vacuum pipe to the clip.
  12. Install the secondary bulkhead right panel.

    Refer to: SECONDARY BULKHEAD RIGHT PANEL

  13. Install the secondary bulkhead left panel.

    Refer to: SECONDARY BULKHEAD LEFT PANEL

  14. Vacuum fill the coolant system.

    Refer to: COOLING SYSTEM PARTIAL DRAINING AND VACUUM FILLING 

scientia non olet · About LEMON Manuals