LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2015 >> Range Rover Autobiography >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Engine Cooling - V6 S/C 3.0L Petrol -- Range Rover/L405) >> Engine Cooling - V6 S/C 3.0L Petrol >> Cooling System Partial Draining And Vacuum Filling >> General Procedures >> Draining

General Procedures: Draining

WARNING: This page is about a different variant/trim than selected.
WARNING: Since injury such as scalding could be caused by escaping steam or coolant, do not remove the filler cap from the coolant expansion tank while the system is hot.
CAUTION: The engine cooling system must be maintained with the correct concentration and type of anti-freeze solution to prevent corrosion and frost damage. Failure to follow this instruction may result in damage to the engine.
NOTE: Some variation in the illustrations may occur, but the essential information is always correct.
  1. WARNING: Make sure to support the vehicle with axle stands.

    Raise and support the vehicle.

  2. WARNING: When releasing the cooling system pressure, cover the coolant expansion tank cap with a thick cloth.
    CAUTION: Since injury such as scalding could be caused by escaping steam or coolant, make sure the vehicle cooling system is cool prior to carrying out this procedure.
    G11715289
  3. Remove engine undershield

    Refer to: ENGINE UNDERSHIELD .

  4. CAUTION: Be prepared to collect escaping coolant.
    NOTE: Collect the coolant in a clean container and reuse.
    G11715290
  5. G11715290

    Torque Specification: 5 Nm 

scientia non olet · About LEMON Manuals