LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2015 >> Range Rover Autobiography >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine - V6 S/C 3.0L Petrol -- Range Rover/L405) >> Engine - V6 S/C 3.0L Petrol >> Valves >> Removal And Installation >> Removal

Removal And Installation: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Refer to: SPECIFICATIONS
  2. WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.

    Raise and support the vehicle.

  3. Refer to: LEFT CYLINDER HEAD 
  4. Refer to: RIGHT CYLINDER HEAD 
  5. G11607195

    Special Tool(s): 303-252 

  6. G11607196
  7. G11607197

    Special Tool(s): 303-884 

  8. CAUTION: Make sure that the area around the component is clean and free of foreign material.
    G11607198
    • Place a small amount of fine valve grinding paste evenly around the contact face of the valve.
    • Place the valve in position and, using a suitable valve grinding tool, rotate the valve back and forth a few degrees on its seat, using light pressure.
    • Raise the valve frequently during lapping and turn it into a new position after a few laps or rotations.
    • Lap only until a continuous but narrow lapping mark is visible on both the valve seat and valve face.
    • Thoroughly clean all surfaces to remove traces of valve grinding paste from the cylinder head, valve seat and valve face.
scientia non olet · About LEMON Manuals