LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2015 >> Range Rover Autobiography >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine - V6 S/C 3.0L Petrol -- Range Rover/L405) >> Engine - V6 S/C 3.0L Petrol >> Right Valve Cover >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page is about a different variant/trim than selected.
  1. CAUTION: Use only a plastic scraper when removing the sealing material.
    NOTE: Apply two beads of silicone gasket sealant (Loctite 5901G or Loctite 5900) as shown on the illustration. The application of the sealant must be 1.5mm diameter 12mm long. Install the valve cover immediately after applying the sealant. The cover should be fitted directly to the head without smearing the sealant or the seals.
    G11607140

    To install, reverse the removal procedure.

  2. G11712778

    Install new seals.

  3. NOTE: LH illustration shown, RH is similar
    G11607141

    Special Tool(s): 303-1446 

  4. NOTE: Tighten the bolts in the indicated sequence.
    Fig 1: Right Valve Cover Bolts
    G11607152Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

    Torque Specification: 13 Nm 

scientia non olet · About LEMON Manuals