Removal And Installation: Installation
WARNING: This page is about a different variant/trim than selected.
Only tighten the bolts finger-tight at this stage.
Torque Specifications:
Stage 1: 45 Nm
Stage 2: 60°
-
Torque Specification: 32 Nm
Torque Specification: 110 Nm
Torque Specification: 9 Nm
- Renew Part: Steering column lower shaft lower bolt Quantity: 1 .
- Torque Specification: 30 Nm
- Install the starter motor.
Refer to: STARTER MOTOR
- Install the exhaust system.
Refer to: EXHAUST SYSTEM
- Connect the battery ground cable.
Refer to: BATTERY AND CABLES