LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2015 >> Range Rover Autobiography >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine - V6 S/C 3.0L Petrol -- Range Rover/L405) >> Engine - V6 S/C 3.0L Petrol >> Right Camshaft >> Removal And Installation >> Removal

Removal And Installation: Removal

WARNING: This page is about a different variant/trim than selected.
CAUTION: Make sure that the orientation and code on the top of the camshaft bearing caps is noted (along with the bank - A or B), so that on installation the components are installed to their original position. Failure to follow this instruction may cause damage to the vehicle.
NOTE: Removal steps in this procedure may contain installation details.
  1. Disconnect the battery ground cable.

    Refer to: SPECIFICATIONS

  2. WARNING: Make sure to support the vehicle with axle stands.

    Raise and support the vehicle.

  3. Refer to: TIMING DRIVE COMPONENTS 
  4. CAUTION: Rotate the camshafts until all the valves are at their minimum open point.
    NOTE: Remove the camshaft bearing caps.
    NOTE: Their position, orientation and markings. Each is marked with its position (number) and an orientation (arrow).
    G11606653
scientia non olet · About LEMON Manuals