LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2015 >> Range Rover Autobiography >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine - V6 S/C 3.0L Petrol -- Range Rover/L405) >> Engine - V6 S/C 3.0L Petrol >> Crankshaft Pulley >> Removal And Installation >> Removal

Removal And Installation: Removal

WARNING: This page is about a different variant/trim than selected.
NOTE: This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
  1. Disconnect the startup battery ground cable.

    Refer to: SPECIFICATIONS

  2. Raise and support the vehicle on a suitable 2 post lift.

    Refer to: LIFTING

  3. Remove the cooling fan.

    Refer to: COOLING FAN SHROUD

  4. Remove the starter motor.

    Refer to: STARTER MOTOR

  5. G11712310

    Remove the supercharger drive belt.

  6. G11712311

    Remove the accessory drive belt.

  7. G11607275
    • Install the special tool.
    • Vehicles without Auto stop/start system.

      Special Tool(s): 303-1448 

    • Vehicles with Auto stop/start system.

      Special Tool(s): JLR-303-1304 

  8. G11606906

    Remove the bolts.

  9. G11606907
    • Install the special tools.
    • Special Tool(s): 303-1437 
    • Special Tool(s): 303-1438 
  10. G11606908

    Install the bolts.

    Torque Specification: 25 Nm 

  11. G11607275
    • Remove the special tool.
    • Vehicles without Auto stop/start system.

      Special Tool(s): 303-1448 

    • Vehicles with Auto stop/start system.

      Special Tool(s): JLR-303-1304 

  12. G11606909
    • Using a suitable vehicle stand, support the special tools.
    • Special Tool(s): 303-1437 
    • Special Tool(s): 303-1438 
  13. NOTE: The crankshaft pulley bolt will be very tight.
    G11606910

    Remove the crankshaft pulley bolt.

  14. G11607275
    • Install the special tool.
    • Vehicles without Auto stop/start system.

      Special Tool(s): 303-1448 

    • Vehicles with Auto stop/start system.

      Special Tool(s): JLR-303-1304 

  15. G11606908
    • Remove the two bolts.
  16. G11606907
    • Remove the special tools.
    • Special Tool(s): 303-1437 
    • Special Tool(s): 303-1438 
  17. G11606913

    Remove and discard the bolt.

  18. G11606914

    Remove the bolts.

  19. G11606915
    • Install the special tool.
    • Special Tool(s): 303-1440 
  20. G11606916
    • Install the special tool.
    • Special Tool(s): 303-1441 
  21. G11606917
    • Install the special tool.
    • Special Tool(s): 303-1439 
  22. G11606918

    Rotate the special tool nut to remove the crankshaft pulley.

  23. NOTE: Make sure to clean the threads in the end of the crankshaft and that the crank nose is free of any foreign materials.
    G11606919
    • Remove the crankshaft pulley.
  24. G11606920

    Remove the special tool.

  25. G11606921

    Remove the special tool.

scientia non olet · About LEMON Manuals