Removal And Installation: Installation

WARNING: This page is about a different variant/trim than selected.

CAUTION: Care must be taken not to damage the body work.
- Install the fuel filler pipe.
- Tighten the nut and bolt.
Torque Specification: 10 Nm
Install new front subframe bolts finger tight.
Renew Part: Rear subframe to body bolts Quantity: 1 .
NOTE: Repeat this step for the other side.

Install the front subframe support bracket bolts.

Torque Specification: 60 Nm
Fully tighten the rear subframe bolts.
Torque Specification: 170 Nm
Remove the transmission jack.
NOTE: Repeat this step for the other side.

Install the bolts and clip.
Install the driveshaft.
Refer to: REAR DRIVESHAFT - V6 S/C 3.0L PETROL/V8 N/A 5.0L PETROL/V8 S/C 5.0L PETROL
CAUTION: Nuts and bolts must be tightened with vehicle at normal ride height.

NOTE: Repeat this step for the other side.
- Support the lower arms with suitable axle stands.
- Install a new nut and bolt to the shock absorber.
Renew Part: Shock absorber nut and bolt Quantity: 1 .

Torque Specifications:

Stage 1: 100 Nm

Stage 2: 240°
NOTE: Repeat this step for the other side.

Install the air suspension hoses to the body.
Connect the electrical connector.
- Install the breather hose on to the fuel filler pipe.
- Install the evaporative emission cannister hose.
Install the right rear wheel arch liners.
Refer to: REAR WHEEL ARCH LINER
Install the rear road wheels.
Refer to: WHEEL AND TIRE - TDV6 3.0L DIESEL/TDV8 4.4L DIESEL/V6 S/C 3.0L PETROL/V8 N/A 5.0L PETROL/V8 S/C 5.0L PETROL
Instal the nut on to the fuel filler pipe.
- Install the fuel filler flap assembly.
- Install the trim around the fuel filler pipe.
- Install the fuel filler cap.
Using the Land Rover approved diagnostic system, pressurize the air suspension.
Refer to: AIR SUSPENSION SYSTEM DEPRESSURIZE AND PRESSURIZE