Fuel Level Sensors - Resistance/Fuel Gauge Read Out Table
WARNING: This page is about a different variant/trim than selected.
NOTE:
These figures are with vehicle on level ground. Sensor readings will defer with varying vehicle inclinations.
Active Side of the Tank:-
| SENDER UNIT RESISTANCE, OHMS | NOMINAL GAUGE READING |
|---|---|
| 992 | Empty |
| 51 | Full |
Passive Side of the Tank:-
| SENDER UNIT RESISTANCE, OHMS | NOMINAL GAUGE READING |
|---|---|
| 992 | Empty |
| 182 | Full |
When the fuel level becomes low, a low fuel warning indicator in the instrument cluster is illuminated and a message is displayed.
The signals from the fuel level sensors are passed to the Body Control Module/Gateway Module (BCM/GWM). The BCM/GWM converts the signals into a Controller Area Network (CAN) message. The data is then passed to the Instrument Cluster (IC) on the high speed CAN chassis systems bus as a direct interpretation of the fuel tank contents in liters.