LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2015 >> Range Rover Autobiography >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Fuel Charging & Controls - V6 S/C 3.0L Petrol -- Range Rover/L405) >> Fuel Charging And Controls - V6 S/C 3.0L Petrol >> Throttle Body >> Removal And Installation >> Removal

Removal And Installation: Removal

WARNING: This page is about a different variant/trim than selected.
NOTE: Removal steps in this procedure may contain installation details.
  1. Disconnect the battery ground cable.

    Refer to: SPECIFICATIONS

  2. WARNING: Make sure to support the vehicle with axle stands.

    Raise and support the vehicle.

  3. Refer to: COOLING SYSTEM PARTIAL DRAINING AND VACUUM FILLING
  4. G11607786
  5. G11607787
  6. NOTE: This step should only be carried out on vehicles pre 2015.
    G11607788

    Renew Part: Engine coolant outlet seal Quantity: 1  .

    Torque Specification: 10 Nm 

  7. NOTE: This step should only be carried out on vehicles from 2015 onwards.
    G11607789

    Renew Part: Engine coolant outlet seal Quantity: 1  .

    Torque Specification: 10 Nm 

  8. G11607790
  9. G11607791

    Torque Specification: 10 Nm 

  10. CAUTION: Do not attempt to clean the throttle body bore, build up of deposits reduces air leakage past the throttle plate at the fully closed position.
    G11607792
    • Remove and discard the gasket.
    • Install a new gasket.

      Renew Part: Throttle body gasket Quantity: 1  .

    • Clean the components mating faces.
scientia non olet · About LEMON Manuals