LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2015 >> Range Rover Autobiography >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Electronic Engine Controls - V6 S/C 3.0L Petrol -- Range Rover/L405) >> Electronic Engine Controls - V6 S/C 3.0L Petrol >> Right Mid Catalyst Heated Oxygen Sensor >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page is about a different variant/trim than selected.
  1. CAUTION: Make sure the anti-seize compound does not contact the HO2S tip.
    NOTE: If the original sensor is to be installed, apply lubricant meeting specification ESE-M12A4-A to the thread of the sensor.
    • Using the special tool install the Heated Oxygen Sensor (HO2S). Special Tool(s): JLR-303-1666  Torque: 48 Nm 
    • Connect the electrical connector.
  2. Install the transmission undershield. Torque Specifications:
    • M10 60 Nm 
    • M6 10 Nm 
scientia non olet · About LEMON Manuals