LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2015 >> Range Rover Autobiography >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Electronic Engine Controls - V6 S/C 3.0L Petrol -- Range Rover/L405) >> Electronic Engine Controls - V6 S/C 3.0L Petrol >> Pre Catalyst Heated Oxygen Sensor >> Removal And Installation >> Removal

Removal And Installation: Removal

WARNING: This page is about a different variant/trim than selected.
WARNING: Observe due care when working near a hot exhaust system.
NOTE: This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.

  1. Raise and support the vehicle.

  2. Remove the front driveshaft. Refer to: FRONT DRIVESHAFT - V6 S/C 3.0L PETROL/V8 N/A 5.0L PETROL/V8 S/C 5.0L PETROL
  3. G00570061
    • Disconnect the electrical connector.
    • Using the special tool remove the Heated Oxygen Sensor (HO2S). Special Tool(s): JLR-303-1666 
scientia non olet · About LEMON Manuals