LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2015 >> Range Rover Autobiography >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Electronic Engine Controls - V6 S/C 3.0L Petrol -- Range Rover/L405) >> Electronic Engine Controls - V6 S/C 3.0L Petrol >> Electronic Engine Controls DTC: Heated Oxygen Sensors >> Diagnosis And Testing >> Drive Cycle >> Notes

Drive Cycle: Notes

WARNING: This page is about a different variant/trim than selected.

Pre catalyst and Mid catalyst sensors 

Drive the vehicle until the engine is fully warm (greater than +80 °C). The drive cycle should include driving the vehicle in a steady throttle condition at a road speed of 30 mph or above for a duration of at least 2 minutes. (Once functional the oxygen sensor output signal can be seen reacting to changes in engine speed/load or if the sensor is faulty a DTC(s) will be raised).

Post catalyst sensors 

Post catalyst sensor monitoring can take over 30 minutes of driving to become active if the 'dew point' has not been achieved in previous drive cycles or an EMS ECU battery reset has occurred. The Drive cycle should consist of a constant speed and load allowing sufficient heat to build up in the exhaust system.

scientia non olet · About LEMON Manuals