LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2015 >> Range Rover Autobiography >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Electronic Engine Controls - V6 S/C 3.0L Petrol -- Range Rover/L405) >> Electronic Engine Controls - V6 S/C 3.0L Petrol >> Electronic Engine Controls (Description And Operation) >> Description And Operation >> Operation >> Crankshaft Position Sensor

Crankshaft Position Sensor

WARNING: This page is about a different variant/trim than selected.

The characteristics of the signal supplied by the Crankshaft Position (CKP) sensor are learned by the Powertrain Control Module (PCM). This enables the PCM to set an adaption and support the engine misfire detection function. Due to a small variation between different drive plates and different CKP sensors, the adaption must be reset if either component is renewed, or removed and refitted. It is also necessary to reset the drive plate adaption if the PCM is renewed or replaced. The PCM supports four drive plate adaptions for the CKP sensor. Each adaption relates to a specific engine speed range. The engine speed ranges are detailed in the chart below:

ADAPTION ENGINE SPEED - REVOLUTION PER MINUTE (RPM)
1 1800 - 3000
2 3001 - 3800
3 3801 - 4600
4 4601 - 5400
scientia non olet · About LEMON Manuals