LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2015 >> Range Rover Autobiography >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Electronic Engine Controls - V6 S/C 3.0L Petrol -- Range Rover/L405) >> Electronic Engine Controls - V6 S/C 3.0L Petrol >> Electronic Engine Controls (Description And Operation) >> Description And Operation >> Description >> Manifold Absolute Pressure And Temperature Sensor

Manifold Absolute Pressure And Temperature Sensor

WARNING: This page is about a different variant/trim than selected.
G11608566

The Manifold Absolute Pressure and Temperature (MAPT) sensor allows the Powertrain Control Module (PCM) to calculate the charge air density immediately before it enters the cylinders. This is used to adjust the ignition timing relative to the boost pressure, and to monitor the performance of the charge air coolers.

The MAPT sensor is installed in the rear of the left intake manifold. The sensor is secured with a single screw and sealed with an O-ring. A four pin electrical connector provides the interface with the engine harness.

scientia non olet · About LEMON Manuals