LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2015 >> Range Rover Autobiography >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Electronic Engine Controls - V6 S/C 3.0L Petrol -- Range Rover/L405) >> Electronic Engine Controls - V6 S/C 3.0L Petrol >> Crankshaft Position Sensor >> Removal And Installation >> Removal

Removal And Installation: Removal

WARNING: This page is about a different variant/trim than selected.
NOTE: Removal steps in this procedure may contain installation details.
  1. Disconnect the battery ground cable.

    Refer to: SPECIFICATIONS

  2. WARNING: Make sure to support the vehicle with axle stands.

    Raise and support the vehicle.

  3. G11699362

    Torque Specifications: 

    M10 60 Nm 

    M6 10 Nm 

  4. CAUTION: Before the disconnection or removal of any components, make sure the area around joint faces and connections are clean. Plug any open connections to prevent contamination.
    G11608587

    Torque Specification: 10 Nm 

scientia non olet · About LEMON Manuals