LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2015 >> Range Rover Autobiography >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Electronic Engine Controls - V6 S/C 3.0L Petrol -- Range Rover/L405) >> Electronic Engine Controls - V6 S/C 3.0L Petrol >> Brake Pedal Position Switch Adjustment >> General Procedures >> Adjust

General Procedures: Adjust

WARNING: This page is about a different variant/trim than selected.
NOTE: The Brake Pedal Position Switch is self adjusting when removed and installed.
  1. Remove and install Brake Pedal Position Switch.

    For additional information, refer to: STOPLAMP SWITCH

  2. Check the adjustment of the stop lamp switch by following the Check  procedure in this procedure and carry out the Adjust  procedure if required.
scientia non olet · About LEMON Manuals