Removal And Installation: Installation

WARNING: This page is about a different car, the 2018 Land Rover Range Rover, 2017 Land Rover Range Rover, and 2016 Land Rover Range Rover. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: Do not use any lubricant on the crankshaft front seal, special tools or the crankshaft. Failure to follow this instruction may result in damage to the vehicle.

NOTE: Make sure that all the component mating faces are clean.

Install a new crankshaft front seal to the special tool.

Special Tool(s): 303-1122

Renew Part: Crankshaft front oil seal Quantity: 1 .
Reposition the crankshaft front seal along the special tool.

Special Tool(s): 303-1122
Install the special tool to the crankshaft.

Special Tool(s): 303-1122
Remove the special tool.
Install the special tool to the crankshaft.

Special Tool(s): 303-1121
NOTE: Make sure the seal is installed correctly.

Using the special tool, install the crankshaft front oil seal.

Special Tool(s): 303-1121

CAUTION: Make sure the seal is installed correctly.

NOTE: Wait 10 seconds before removing the crankshaft seal installation tool.
Remove the special tool.
Install the crankshaft pulley.
Refer to: CRANKSHAFT PULLEY - TDV6 3.0L DIESEL - GEN 2
Remove the special tool.

Special Tool(s): 303-1123
Install the timing belt.
Refer to: TIMING BELT
Connect the battery ground cable.
Refer to: SPECIFICATIONS