Possible Causes
WARNING: This page is about a different car, the 2018 Land Rover Range Rover, 2017 Land Rover Range Rover, and 2016 Land Rover Range Rover. However, it is still accessible from the selected car via links, so may be relevant.
- Purpose of the DTC
- Monitoring PWM signal of crankshaft sensor
- Electrical Cause
- Yes
- Mechanical Cause
- Yes
- Control module cavity
- Circuit reference O_V_5VCRS
- Circuit reference I_F_CRS
- Circuit reference G_G_CR S
- Monitor Description
- If the monitor detects a disturbed crankshaft signal for a specific crankshaft rotation segment, an error counter will be incremented. If the error counter "disturbed crankshaft signal" is above a threshold, the DTC will be set
- Prioritised List of Possible Causes
- Crankshaft position sensor incorrectly installed
- Crankshaft position sensor air gap to target rotor excessive, debris on sensor face, damaged teeth on rotor
- Crankshaft position sensor circuit short circuit to ground, short circuit to power, open circuit, high resistance
- Connector is disconnected, connector pin is backed out, connector pin corrosion
- Crankshaft position sensor failure