Possible Causes
WARNING: This page is about a different car, the 2018 Land Rover Range Rover, 2017 Land Rover Range Rover, and 2016 Land Rover Range Rover. However, it is still accessible from the selected car via links, so may be relevant.
- Electrical Cause
- Yes
- Mechanical Cause
- Yes
- Control module cavity
- Circuit reference G_G_CR S
- Circuit reference O_V_5VCRS
- Circuit reference I_F_CRS
- The powertrain control module detected the low pulse is too narrow with respect to time
- Crankshaft position sensor incorrectly installed
- Crankshaft position sensor air gap to target rotor excessive, debris on sensor face, damaged teeth on rotor
- Crankshaft position sensor circuit short circuit to ground, short circuit to power, open circuit, high resistance
- Connector is disconnected, connector pin is backed out, connector pin corrosion
- Crankshaft position sensor failure