DTC U0151-08: Lost Communication With Restraints Control Module - Bus signal/message failures: Action

WARNING: This page is about a different car, the 2018 Land Rover Range Rover, 2017 Land Rover Range Rover, 2016 Land Rover Range Rover, 2014 Land Rover Range Rover, and 2013 Land Rover Range Rover. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

If B10A2-32 is also set, check the restraints control module power and ground circuits for open circuit, high resistance.
If B10A2-32 and U0151-00 are also set, check the crash signal circuit for short circuit to ground, short circuit to power, open circuit, high resistance.

Refer to the appropriate system wiring diagram and check the restraints control module power and ground circuits for open circuit, high resistance. Repair the wiring harness as necessary
Using the Jaguar Land Rover approved diagnostic equipment, perform a CAN network integrity test. Refer to the appropriate system wiring diagram and check the high speed CAN bus (chassis) circuit for short circuit to ground, short circuit to power, open circuit, high resistance. Repair the wiring harness as necessary
Refer to the appropriate system wiring diagram and check the FlexRay bus circuit for short circuit to ground, short circuit to power, open circuit, high resistance. Repair the wiring harness as necessary
Using the Jaguar Land Rover approved diagnostic equipment, check the restraints control module for related DTCs and refer to the relevant DTC index