DTC P0336-03: Crankshaft Position Sensor A Circuit Range/Performance - FM (Frequency Modulated)/PWM (Pulse Width Modulated) failures: Action
WARNING: This page is about a different car, the 2018 Land Rover Range Rover, 2017 Land Rover Range Rover, 2016 Land Rover Range Rover, 2014 Land Rover Range Rover, and 2013 Land Rover Range Rover. However, it is still accessible from the selected car via links, so may be relevant.
- Refer to appropriate system wiring diagram and check the crankshaft position sensor circuit for short circuit to ground, short circuit to power, open circuit, high resistance
- Inspect connectors for signs of water ingress, and pins for damage and/or corrosion
- Check crankshaft position sensor air gap to target rotor is correct
- Check and install a new crankshaft position sensor as required