DTC P0332-21: Knock/Combustion Vibration Sensor 2 Circuit Low Bank 2 - Signal amplitude < minimum: Action
WARNING: This page is about a different car, the 2018 Land Rover Range Rover, 2017 Land Rover Range Rover, 2016 Land Rover Range Rover, 2014 Land Rover Range Rover, and 2013 Land Rover Range Rover. However, it is still accessible from the selected car via links, so may be relevant.
- Check powertrain control module for related misfire DTCs and refer to this DTC index. Rectify these first
- Refer to the appropriate system wiring diagram and check knock sensor circuit for short circuit to ground, short circuit to power
- Measure knock sensor circuit for correct resistance
- 1 to 1.8 Mega Ohms
- Inspect connectors for signs of water ingress, and pins for damage and/or corrosion
- Using the Jaguar Land Rover approved diagnostic equipment, clear the DTCs and retest
- Check and install a new knock sensor as required