DTC P032D-22: Knock/Combustion Vibration Sensor 3 Circuit High Bank 1 - Signal amplitude > maximum: Action
WARNING: This page is about a different car, the 2018 Land Rover Range Rover, 2017 Land Rover Range Rover, 2016 Land Rover Range Rover, 2014 Land Rover Range Rover, and 2013 Land Rover Range Rover. However, it is still accessible from the selected car via links, so may be relevant.
- Refer to the appropriate system wiring diagram and check knock sensor circuit for short circuit to power
- Measure knock sensor circuit for correct resistance
- 1 to 1.8 Mega Ohms
- Inspect connectors for signs of water ingress, and pins for damage and/or corrosion
- Check for abnormal engine noise that may corrupt the knock sensor signal
- Using the Jaguar Land Rover approved diagnostic equipment, clear the DTCs and retest
- Check and install a new knock sensor as required