Possible Causes
WARNING: This page is about a different car, the 2018 Land Rover Range Rover, 2017 Land Rover Range Rover, 2016 Land Rover Range Rover, 2014 Land Rover Range Rover, and 2013 Land Rover Range Rover. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
This DTC is set when the powertrain control module measures a signal that remains low when transitions are expected.
- Battery disconnection resulting in errors in engine off time (short soaks may look like long soaks)
- Electric block heater applied and not detected
- Connector is disconnected, connector pin is backed out, connector pin corrosion
- Ambient air temperature sensor failure