DTC P0105-84: Manifold Absolute Pressure/Barometric Pressure Sensor Circuit - Signal below allowable range: Action
WARNING: This page is about a different car, the 2018 Land Rover Range Rover, 2017 Land Rover Range Rover, and 2016 Land Rover Range Rover. However, it is still accessible from the selected car via links, so may be relevant.
- Diagnosis of this DTC may require using the Jaguar Land Rover approved diagnostic equipment to check datalogger signals:
- 0x0322 Corrected Intake Manifold Absolute Pressure - kPa
- 0x033E Boost Absolute Pressure - Raw Value - kPa
- 0x052C Manifold Absolute Pressure Bank 1 - kPa
- 0xF40B Intake Manifold Absolute Pressure - kPa
- Refer to the appropriate system wiring diagram and check the manifold absolute pressure and temperature sensor circuit for short circuit to ground
- Inspect connectors for signs of water ingress, and pins for damage and/or corrosion
- Check and install a new manifold absolute pressure and temperature sensor as required
- Using the Jaguar Land Rover approved diagnostic equipment, clear the DTCs and retest