DTC P24AE-96: Particulate Matter Sensor Circuit - Component internal failure: Action
WARNING: This page is about a different car, the 2018 Land Rover Range Rover, 2017 Land Rover Range Rover, and 2016 Land Rover Range Rover. However, it is still accessible from the selected car via links, so may be relevant.
- Vehicle Conditions to enable DTC Logging Strategy
- Monitor runs once when post selective catalyst reduction soot sensor is in regeneration (requires driving for 20 minutes and visible, check 0xD940 ~ 785°C)
- Prioritised Checks to Perform
- Diagnosis of this DTC may require using the Jaguar Land Rover approved diagnostic equipment check datalogger signals
- 0xD940 Particulate Matter Sensor Meander Temperature - Raw
- Refer to the appropriate system wiring diagram and check the CAN_L_3 and CAN_3_H circuit for short circuit to ground, open circuit, high resistance
- Refer to the appropriate system wiring diagram and check the post selective catalyst reduction soot sensor circuit for short circuit to ground, open circuit, high resistance
- Inspect connectors for signs of water ingress, and pins for damage and/or corrosion
- Check post selective catalyst reduction soot sensor for soot deposits on probe
- Check post selective catalyst reduction soot sensor for water deposits on probe
- Check and install a new post selective catalyst reduction soot sensor as required
- Check DPF for substrate damage
- Using the Jaguar Land Rover approved diagnostic equipment check powertrain control module for related DTCs and refer to relevant DTC index