LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2015 >> Range Rover Autobiography >> Repair and Diagnosis >> External Pages >> Different car >> Section 10 (Electronic Engine Controls - TDV6 3.0L Diesel -- Range Rover/L405) >> Electronic Engine Controls - TDV6 3.0L Diesel >> Pre Catalytic Converter Temperature Sensor >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page is about a different car, the 2018 Land Rover Range Rover, 2017 Land Rover Range Rover, and 2016 Land Rover Range Rover. However, it is still accessible from the selected car via links, so may be relevant.
  1. CAUTION:
    • If accidentally dropped or knocked install a new sensor.
    • Make sure that the mating face is clean and free of foreign material.
    NOTE: If the original sensor is to be installed, apply lubricant meeting specification ESE-M12A4-A to the thread of the sensor.
    G11772175

    Torque Specification: 35 Nm 

  2. G11772174
  3. Install the front driveshaft.

    Refer to: FRONT DRIVESHAFT - TDV6 3.0L DIESEL

scientia non olet · About LEMON Manuals