REAR COOLANT MANIFOLD - V8 S/C 5.0L Petrol: Installation

NOTE:
- If equipped.
- This step is only required if new components are not installed.
Install 3 new O-ring seals to the rear coolant manifold

Renew Part: Cylinder block coolant outlet O-ring seals Quantity: 3 .
NOTE: This step is only required if new components are not installed.

Install 2 new O-ring seals to the rear coolant manifold.

Renew Part: Cylinder block coolant outlet O-ring seals Quantity: 2 .
- Install the rear coolant manifold.
- Install and tighten the 4 bolts.
  Torque : 9Nm
- Reposition the breather pipe into the correct location.
- Install the clip.
- Connect the electrical connector.
- Install the wiring harness clip.
- Connect the rear coolant manifold left hose.
- Install the coolant hose clip.
- Install the rear coolant manifold right hose.
- Connect the 2 coolant hose connectors.
Install the secondary bulkhead left panel.
Refer to: SECONDARY BULKHEAD LEFT PANEL .
Install the secondary bulkhead right panel.
Refer to: SECONDARY BULKHEAD RIGHT PANEL .
Vacuum fill the coolant system.
Refer to: COOLING SYSTEM PARTIAL DRAINING AND VACUUM FILLING .